User's Manual

357-3
Declaration of Conformity
This mobile phone complies with the EU
requirements for exposure to radio waves.
Your mobile phone is a radio transceiver, designed
and manufactured not to exceed the SAR* limits** for
exposure to radio-frequency (RF) energy, which
SAR* value, when tested for compliance against the
standard was ★.★★★ W/kg. While there may be
differences between the SAR* levels of various
phones and at various positions, they all meet*** the
EU requirements for RF exposure.
* The exposure standard for mobile phones
employs a unit of measurement known as the
Specific Absorption Rate, or SAR.
** The SAR limit for mobile phones used by the
public
is 2.0 watts/kilogram (W/kg) averaged over
ten grams of tissue, recommended by The
Council of the European Union. The limit
incorporates a substantial margin of safety to give
additional protection for the public and to account
for any variations in measurements.
*** Tests for SAR have been conducted using
standard operating positions with the phone
transmitting at its highest certified power level in
all tested frequency bands. Although the SAR is
determined at the highest certified power level,
the actual SAR level of the phone while operating
can be well below the maximum value. This is
because the phone is designed to operate at
multiple power levels so as to use only the power
required to reach the network. In general, the
closer you are to a base station antenna, the
lower the power output.
FCC RF Exposure Information
Your handset is a radio transmitter and recei ver.
It is designed and manufactured not to exceed
the emission limits for exposure to radio
frequency (RF) energy set by the Federal
Communications Commission of the U.S.
Government.
The guidelines are based on standards that were
developed by independent scientific
organisations through periodic and thorough
evaluation of scientific studies. The standards
include a substantial safety margin designed to
assure the safety of all persons, regardless of age
and health.
The exposure standard for wi reless handsets
employs a unit of measurement known as the
Specific Absorption Rate, or SAR.
The SAR limit
set by the FCC is 1.6 W/kg.
The tests are performed in positions and locations
(e.g., at the ear and worn on the body) as
required by the FCC for each model. The highest
SAR value for this model handset when tested for
use at the ear i s ★.★★★ W/kg and when worn
on the body, as described in this user guide, is ★
.★★★ W/kg.
Body-worn Operation; This device was tested for
typical body-worn operations with the back of the
handset kept 1.5 cm from the body. To maintain
compliance with FCC RF exposure requirements,
use accessories that maintain a 1.5 cm
separati
on distance between the user’s body and
the back of the handset. The use of belt clips,
holsters and similar accessories should not
contain metallic components in its assembly.
The use of accessories that do not satisfy these
requirements may not comply with FCC RF
exposure requirements, and should be avoided.
The FCC has granted an Equipment
Authorisation for this model handset with all
reported SAR levels evaluated as in compliance
with the FCC RF emission guidelines. SAR
information on this model handset is on file with
the FCC and can be found under the Display
Grant section of http://www.fcc.gov/oet/fccid after
searchi
ng on FCC ID XXXXXXXXXX.
Additional information on Specific Absorption
Rates (SAR) can be found on the Cellular
Telecommunications & Internet Association
(CTIA) website at http://www.phonefacts.net.
The product “FOMA D905i” is declared to
conform with the essential requirements of
European Union Directive 1999/5/EC Radio
and Telecommunications Terminal
Equipment Directive 3.1(a), 3.1(b) and 3.2.