Installation manual

REV 2.4

4. Adjustment software, “Wallaby”

4.1. General

“Wallaby” is a software program that can adjust a display wall through RS-232 format

communication. Up to 64 cubes in a display wall can be controlled separately according to the

allocated ID numbers.

This software works with Microsoft

Windows

95, Windows 98, Windows Me, Windows NT

Version4.0, Windows 2000 and Windows XP. It is recommended to use Windows NT Version4.0,

Windows 2000 or later.

4.2. Installation

4.2.1. Software Installation

1. Insert the set-up disk or copy the set-up files into a control PC and double-click the

Setup.exe.

2. Follow its installation messages until finish.

4.2.2. Connecting

Connect the Wallaby-installed PC to the master cube with a commercially available RS-232 cross

cable. Make sure that each cube in the display wall is connected with supplied control cables.

(Refer to chapter

1.3, on page 23.)

4.2.3. Dipswitch setting

Make sure that the dipswitches of the cubes are set correctly. (chapter

1.4.2, on page 28.)

4.2.4. Starting the application

Execute the “Wallaby” for suitable models in Windows

start menu.

4.3. Initial set-up

Main window

4.3.1. Model selecting

Click “Model Select” in “System Config” menu to select suitable model

range to be controlled. When you execute the application from the

appropriate Windows

start menu, this operation is not necessary.