HOMEOWNER KINGSPAN Homeowner’s User Instructions SEPTEMBER 2011 Ecodan® Aerocyl-me: Air Source Heat Pump and Copper Cylinder Ecodan Air Source Heat Pump Model Number • PUHZ-W50VHA(2)-BS • PUHZ-W85VHA(2)-BS • PUHZ-HW140VHA(2)-BS / YHA-BS • PUHZ-HW140VHA-BS(2) / YHA(2)-BS
Homeowner’s User Instructions Introduction The Ecodan air source heat pump extracts thermal energy from the outside air and transfers this into a property in the form of hot water as a conventional heating system does. The Ecodan will provide space heating (through radiators or under floor heating) and domestic hot water (taps, showers, etc). Domestic hot water always takes priority over space heating. The Ecodan Aerocyl-me package is controlled by conventional heating system control equipment.
Ecodan This will be located outdoors (most likely to be in the garden) facing 3 4 ( away from the property. The air is sucked into the back and used to " " heat the refrigerant that is sealed within the unit. " Cold air will be expelled from the front of the unit when the Ecodan is operating. " The homeowner does not need to make any adjustments to this element of the system. , ' Always ensure the front and back are clear of obstructions.
The homeowner should know: How to switch on power to the Ecodan Aerocyl-me This will be located inside the property near the mains power switch, it needs to be switched on. The outdoor unit does not needed to be touched. How to switch off power to the Ecodan Aerocyl-me This will be located inside the property near the mains power switch, it needs to be switched off. If the homeowner is away from the property for several days only switch off the indoor switch.
Troubleshooting Fault Possible Cause Solution Water does not heat up well Ecodan may not be working to its highest capacity. Make sure that there is plenty of space around the outdoor unit so air can flow in and out. Filter may be dirty and needs to be cleaned. Cleaning of this filter should be carried out by your installer. During the heating mode, water may form and drop from the heat exchanger on the outdoor unit. No solution necessary, this will not effect the performance of the Ecodan.
Danfoss 1 Thermostat—User Instructions * $ ,# 1 ,# " ? Your programmable room thermostat allows you to programme at different ?time periods. You"can programme one set of times and temperatures for ? a different set of temperatures for weekend days, this is week days with 0*/ 0*/ referred to as 5/2 day operation. " your installer to provide one set The"thermostat "can also "be set up by of times and temperatures that are repeated each day of the /@ week. This is referred to as 24 hour operation.
2
Instructions * Danfoss $ " #2 Channel , Timeclock—User &1 * The $ FP715 " #Si allows,you to switch &1 your heating and hot water on &(9.0 and off 3at times that suit you. ? ? ? ? &(9.0 3 Your programme has had the date and time set up during manufacture and will automatically change between Greenwich Mean Time and " B 6 A 3 British Summer Time. ! ! B upCto$%*$&& 6 3 the heating You can "programme 3 ON/OFF times perA day for and hot water and" the two systems can be operated independently.
4
4 11
HOMEOWNER FTC KINGSPAN Telephone: 01707 282880 After Sales Service: 0161 866 6089 email: heating@meuk.mee.com web: www.domesticheating.mitsubishielectric.co.
