Instruction manual

App - 4
A
PPENDICES
APPENDIX 1.2 Serial absolute synchronous encoder cable
Generally use the serial absolute synchronous encoder cables available as our
products. If the required length is not found in our products, fabricate the cable on the
customer side.
(1) Selection
The following table indicates the serial absolute synchronous encoder cables
used with the serial absolute synchronous encoder.
Connector sets (Q170ENCCNS) are also available for your fabrication.
Table 1 Wire models
Type Length [m(ft.)] Wire model
Q170ENCCBLM
2(6.56), 5(16.40), 10(32.81), 20(65.62),
30(98.43), 50(164.04)
M14B0023 12 pair (BLACK)
Use the following or equivalent twisted pair cables as the serial absolute
synchronous encoder cables.
Table 2 Connector sets
Connector sets type Description
Q170ENCCNS
• Connector shell kits
• Plug cable clump
Table 3 Wire specifications
Characteristics of one core
Wire model
Core
size
[mm
2
]
Number of
cores
Structure
[Number of
wires/mm]
Conductor
resistance
[
/km]
Insulating
sheath OD
d[mm
(inch)]
(Note-1)
Finished
OD
[mm (inch)]
(Note-2)
M14B0023 12 pair (BLACK) 0.2 24(12 pair) 40/0.08 105 or less 0.88 (0.035) 11.0 (0.43)
(Note-1): "d" is as shown below.
Insulation sheath
Conductor
d
(Note-2): Standard OD (Outside Diameter). Maximum OD is about 10% larger.
CAUTION
When fabricating the encoder cable, do not make incorrect connection. Wrong connection will
cause runaway or explosion.