Installation Instructions

206 STARTING AND OPERATING
SELEC-TRACK — IF EQUIPPED (SRT)
Description
Selec-Track combines the capabilities of the
vehicle control systems, along with driver input,
to provide the best performance for all terrains.
Rotate the Selec-Track knob to select the
desired mode.
Selec-Track Switch
Refer to the “Drive Modes Supplement” for
further information.
Selec-Track consists of the following positions:
 SPORT – Dry weather, on-road calibration.
Performance based tuning that provides a
rear wheel drive feel but with improved
handling and acceleration over a two-wheel
drive vehicle. This feature will reset to AUTO
on an ignition cycle.
 SNOW – Tuning set for additional stability in
inclement weather. Use on and off road on
loose traction surfaces such as snow. This
feature will reset to AUTO upon an ignition
cycle.
 AUTO – Fully automatic full time four-wheel
drive operation can be used on and off road.
Balances traction with seamless steering feel
to provide improved handling and accelera-
tion over two-wheel drive vehicles.
 TRACK – Track road calibration for use on
high traction surfaces. Driveline is maximized
for traction. Some binding may be felt on less
forgiving surfaces. This feature will reset to
AUTO on an ignition cycle.
 TOW – Use this mode for towing and hauling
heavy loads. Vehicle suspension will go to
SPORT mode. Trailer Sway Control (TSC) is
enabled in the ESC system. This feature will
reset to AUTO upon an ignition cycle.
Custom
This mode allows the driver to create a custom
vehicle configuration that is saved for quick
selection of favorite settings. The system will
return to AUTO mode when the ignition switch is
cycled from RUN to OFF to RUN, if this mode is
selected. While in CUSTOM Mode the Stability,
Transmission, Steering, Suspension, all-wheel
drive set up, and Paddle shifter settings may be
configured through the custom mode set-up.
NOTE:
Refer to the “Drive Modes Supplement” for
further information.
20_WK_OM_EN_USC_t.book Page 206