Operating Tips

94 GETTING TO KNOW YOUR INSTRUMENT PANEL
SRT Instrument Cluster Descriptions
1. Speedometer
 Indicates vehicle speed.
2. Tachometer
 Indicates the engine speed in revolutions
per minute (RPM x 1000).
3. Temperature Gauge
 The temperature gauge shows engine
coolant temperature. After an engine
warm up, any reading within
203°F - 230°F (95°C - 110°C) indicates
that the engine cooling system is
operating satisfactorily.
 The pointer will likely indicate a higher
temperature when driving in hot weather,
up mountain grades, or when towing a
trailer. It should not be allowed to exceed
the upper limits of the normal operating
range.
4. Fuel Gauge
 The pointer shows the level of fuel in the
fuel tank when the Keyless Push Button
Ignition is in the ON/RUN position.
 The fuel pump symbol points
to the side of the vehicle where
the fuel door is located.
5. Instrument Cluster Display
 The instrument cluster display features a
driver-interactive display. Refer to
“Instrument Cluster Display” in this
chapter for further information.
NOTE:
The hard telltales will illuminate for a bulb check
when the ignition is first cycled.
WARNING!
A hot engine cooling system is dangerous.
You or others could be badly burned by steam
or boiling coolant. You may want to call an
authorized dealer for service if your vehicle
overheats.
CAUTION!
Driving with a hot engine cooling system
could damage your vehicle. If the
temperature gauge reads greater than 230°F
(110°C) pull over and stop the vehicle. Idle
the vehicle with the air conditioner turned off
until the pointer drops back into the normal
range. If the pointer remains above 230°F
(110°C), turn the engine off immediately and
call an authorized dealer for service.
20_WK_OM_EN_USC_t.book Page 94