Specifications

SAFETY 219
If a reset procedure step is not completed within 60 seconds, then the turn signal lights will blink and the reset procedure must
be performed again in order to be successful.
6. Place turn signal in neutral state.
Right turn light BLINKS.
Left turn light is OFF.
7. Turn right turn signal switch ON.
Right turn light is ON SOLID.
Left turn light BLINKS.
8. Place turn signal in neutral state.
Right turn light is OFF.
Left turn light BLINKS.
9. Turn left turn signal switch ON.
Right turn light is ON SOLID.
Left turn light is ON SOLID.
10. Turn left turn signal switch OFF. (Turn Signal Switch
Must be placed in Neutral State).
Right turn light is OFF.
Left turn light is OFF.
11. Turn ignition STOP/OFF/LOCK.
12. Turn ignition MAR/ACC/ON/RUN. (Entire sequence
needs to be completed within one minute or sequence will
need to be repeated).
System is now reset and the engine may be started.
Turn hazard flashers OFF (Manually).
Customer Action
Customer Will See
NOTE:
Each step MUST BE held for at least two seconds
4
20_BV_OM_EN_US_t.book Page 219