Specifications

312 STARTING AND OPERATING
Front Park Assist Audible Alerts
ParkSense will turn off the Front Park Assist audible alert
(chime) after approximately three seconds when an obstacle
has been detected, and the vehicle is stationary. If the
obstacle has been detected within less than 12 inches (30 cm),
then the Parksense will not turn off the Front Park Assist
audible alert.
Adjustable Chime Volume Settings
Front and Rear chime volume settings can be selected from
the Customer-Programmable Features section of the Ucon-
nect System, refer to “Uconnect Settings” in “Multimedia”
for further information.
If the Uconnect System is equipped, chime volume settings
will not be accessible from the instrument cluster display.
The chime volume settings include low, medium, and high.
The factory default volume setting is medium.
ParkSense will retain its last known configuration state
through ignition cycles.
Enabling And Disabling ParkSense
ParkSense can be enabled and disabled with the ParkSense
switch, located on the switch panel below the Uconnect
display.
When the ParkSense switch is pushed to disable the
system, the instrument cluster display will show the
“ParkSense Disabled” message for approximately
five seconds. Refer to “Instrument Cluster Display” in
“Getting To Know Your Instrument Panel” for further infor-
mation.
The ParkSense switch LED turns on when the system is
disabled by pushing the switch, as well as in case of failure
or temporary disabling conditions. The ParkSense switch
LED will be off when the system is enabled. If the ParkSense
switch is pushed, and requires service, the ParkSense switch
LED will blink momentarily, and then the LED will be on.
20_BV_OM_EN_US_t.book Page 312