Specifications

74 GETTING TO KNOW YOUR VEHICLE
NOTE:
• The Rain Sensing feature will not operate when the wiper
switch is in the low or high-speed position.
• The Rain Sensing feature may not function properly when
ice, or dried salt water is present on the windshield.
• Use of Rain-X or products containing wax or silicone may
reduce Rain Sensing performance.
• The Rain Sensing feature can be turned on and off using
the Uconnect System, refer to “Uconnect Settings” in
“Multimedia” for further information.
Rear Wiper Operation
The rear wiper/washer controls are located on the lever on
the right side of the steering column. The rear wiper/washer
is operated by rotating a switch, located at the middle of the
lever.
NOTE:
If the front wiper is moving and the vehicle is shifted in
REVERSE, the rear wiper will perform one round up to clean
the rear window.
Rotate the center portion of the lever upward to the
first detent for intermittent operation and to the
second detent for continuous rear wiper operation.
If the front wiper is set to Automatic Mode (on the wiper
lever as well as “Enabled” through Uconnect settings),
placing the rear wiper in an intermittent position will cause
the front and rear wipers to sync up. Turning the front
wipers off will cause the rear wipers to also stop.
To use the washer, push the lever forward and hold
while spray is desired. If the lever is pushed while in
the intermittent setting, the wiper will turn on and
operate for several wipe cycles after the end of the lever is
released, and then resume the intermittent interval previ-
ously selected.
If the lever is pushed while the wiper is in the off position,
the wiper will operate for several wipe cycles, then turn off.
NOTE:
As a protective measure, the pump will stop if the switch is
held for more than 30 seconds. Once the lever is released, the
pump will resume normal operation.
20_BV_OM_EN_US_t.book Page 74