- Mitsubishi Digital Electronics VCR User Manual

14
4. Connection with external equipment
The functions of this unit can be set with the menu screens displayed on the monitor.
1 Connection with Monitors Pages 14 - 16
Explains how to connect with a monitor.
Explains the setting of sync. polarity.
, When the sync. polarity of a monitor differs from the initial setting of this unit, the image on the monitor may not be
displayed correctly. In this case, set the sync. polarity according to the monitor.
When the image is displayed on the monitor correctly, the setting is not required.
2 Connection with VIDEO/S-VIDEO (Y/C separate VIDEO) signal equipment Page 17
Explains how to connect with a video signal equipment.
Explains how to connect with a S-video signal equipment.
3 Connection with RGB Analog Signal equipment Page 18
Explains how to connect with a RGB analog signal equipment.
4 Connection with RS-232C equipment Pages 19 - 21
Explains how to connect with a RS-232C equipment.
1 Connection with Monitors
Connect this unit with a monitor to check the images to be printed and the images stored in memory.
The following example shows the connection with a video signal, a S-video signal and RGB analog signal equipment.
Connect with the necessary signal equipment.
When connecting the unit with a monitor, make sure to set the power of each equipment to “OFF” .
To VIDEO OUT termi nal
VIDEO ( )
AC LINE
R G/G+SYNC B H+V-SYNC
R G/G+SYNC B H+V-SYNC
IN
OUT
S-VIDEO
VIDEO
75Ω
HIGH
75Ω
HIGH
IMPEDANCE
SYNC.
RGB
RS-232C
R
G/G+SYNC.
B
H+V-SYNC.
R
G/G+SYNC.
B
H+V-SYNC.
To S-VIDEO OUT terminal
S-VIDEO ( )
To S-VIDEO IN terminal
To RGB Analog OUT
terminals ( )
To RGB Analog IN
terminals
Monitor
VCP
To VIDEO IN terminal
REMOTE
12