- Mitsubishi Digital Electronics VCR User Manual

4. Connection with external equipment (RS-232C Interface)

4 Press the SET

SET

button.

, “CHANGE : OK” is selected.

5 Select “OK”, then, press the SET

SET

button.

, The source image (input signal from the equipment connected) is displayed.

0 The setting of COMMAND TYPE is completed.

RS-232C DATA SIGNAL

RS-232C input connector port signal allocation

Pin No. Signal line name Description Directions (From VCP side)

1 F G Protective ---

2 T X D Transmitted data Output

3 R X D Received data Input

4 R T S Request to send Output

5 C T S Clear to send Input

6 D S R Data set ready Input

7 G N D Signal ground ---

20 D T R Data terminal ready Output

Setting the communication format of the computer

, Set the communication format as follows:

(1) Synchronizing system Asynchronous communication

(2) Data bit length 8 bits

(3) Parity bit Nothing

(4) STOP bit length 1

(5) Transmission order Sent from LSB

(6) Baud rate (Bit / Sec) 1200, 2400, 4800, 9600

RS-232C function

, This unit can be controlled through RS-232C terminal.

( The input of image data is not possible.)

Consult with the sales dealer for the details of controlling

method (protocol).

Pin connection

, Connect the unit with the host computer

through cross-over cable.

Cross-over cable