Manualshelf

- Mitsubishi Digital Electronics VCR User Manual

ManualsBrandsMitsubishi Electronics ManualsVCRCP700E
31323334353637383940
36
6. Printing Procedures (Basic prints)
1 Changing the number of prints during printing
, When changing the number of prints during printing:
1 Press the PRINT Q'ty buttons
, to set the number of prints to 1.
2 After the image being printed is printed out, press the PRINT Q’ty buttons
, to change the number of prints.
Note :
0 If blackish image is continuously printed, the internal temperature may rise and cause the unit to switch to a stand-by
condition during printing.
An error message “OVER HEAT” is displayed on LCD or monitor screen.
In this case, wait until the error message goes off.
Continuous printing resumes when the temperature drops and error message goes off.