- Mitsubishi Digital Electronics VCR User Manual

7. Setting the functions (Main menu)

ANALOG ADJ The adjustment image of analog input signal display

, This menu is used to adjust the image of analog input signal display before storing in the memory.

, This menu is opened when pressing RIGHT

button on “ANALOG ADJ : PUSH [ ] ]” .

, When selecting RGB analog signal, “COLOR” “TINT” is not adjusted and displayed.

BRT (Bright )

Function

Adjust the brightness of printing image.

CONT (Contrast )

Function

Adjust the contrast of printing image.

R-SUB (Red-subcontrast)

Function

Adjust the red-subcontrast of printing image.

B-SUB (Blue-subcontrast)

Function

Adjust the blue-subcontrast of printing image.

COLOR

Function Adjust the color of printing image

, The each function and setting area is as follows.

Item Adjustment -32 Adjusting area +31

B R T Brightness Darker ............................. Brighter

CONT Contrast Less contrast ....................... More contrast

R-SUB Red-subcontrast Add cyan ........................... Add red

B-SUB Blue-subcontrast Add yellow ......................... Add blue

COLOR Color Light .............................. Deep

• When selecting the RGB signal, COLOR is not shown on the monitor display.

CENTER

Function The setting value of “COLOR ADJ” is initialized.

When this function is set to “ON” , the setting value of BRT, CONT, R-SUB , B-SUB, COLOR is reset to 0.

, When pressing the SET

SET

button after selecting “OK” on the lower position “CHANGE : OK/CANCEL” ,

“1.COLOR ADJ” menu is displayed.