- Mitsubishi Digital Electronics VCR User Manual

5
1 Removing the fixed screw on the printing unit and protective cushion Pages 5 - 6
2 Installing the lithium battery Page 6
,Power for memorizing the day and present time are supplied by a lithium battery. Before using this unit
install the lithium battery.
3 Installing the print paper and ink cassette. Pages 7 - 9
, Install the print paper.
, Install the cassette with ink sheet.
4 Setting the present time Pages 10 - 13
, Set the day and present time to print on the lower part of the print.
1 Removing the fixed screw on the printing unit and protective cushion Pag
When using the unit for the first time, remove the fixed screw on the printing unit and protective cushion.
1 Remove the fixed screw on the printing unit.
,There is a fixed screw at the bottom of the printing unit.
1 Remove the fixed screw with a screwdriver or coin.
2 Set the removed screw to the hole on the rear panel for keep the screw.
Attention:
, Keep the removed fixed screw by setting it to the hole on the rear panel. This screw is required when transporting
this unit.
, Make sure you set the fixed screw to the bottom of the unit when transporting the printer.
Fixed screw
R G/G+SYNC B H+V-SYNC
R G/G+SYNC B H+V-SYNC
IN
OUT
S-VIDEO
AC LINE
VIDEO
75Ω
HIGH
75Ω
HIGH
IMPEDANCE
SYNC.
RGB
RS-232C
Stored position
REMOTE
12
3. Preparations before operation