- Mitsubishi Digital Electronics VCR User Manual

6
1 Open the door. 2 Install the battery with the (+) side facing out.
3 Close the door.
1 Remove the protective cushion.
Note: Unplug the power cord from outlet for safety.
1 Press the OPEN button on the front panel.
Printing unit will slide out.
Attention
}}
}}
}
, Do not touch the thermal head.
Fingerprints or dust on the thermal head will degrade the print quality.
2 Pull out the protective cushion from the right side.
Attention
}}
}}
}
, Keep the protective cushion for transporting this unit.
, It is very important to transport this printer with the protective cushion
installed so as not to damage the printing unit.
2 Installing the lithium battery
Power for memory of day and present time are supplied by a lithium battery.
Install the lithium battery ( accessory CR2025) by the following procedure after plugging the VCP.
{ Install the lithium battery to the folder.
, If the installed battery is dead or a battery has been installed incorrectly, the built-in clock and power loss listing will not
function properly.
, When changing the battery, pry the battery out of the holder with a sharp object.
, After changing the battery, set the present time and day.
Note:
, Take care of the battery. Refer to pages on lithium battery precaution.
, The setting before installing the battery is not valid. When operating this unit without any settings, the strobe function
may not be operated.
Folder
Protective cushion
3. Preparations before operation
, If the installed battery is dead or a battery has been installed incorrectly, the built-in clock and power loss listing will not
function properly.
, When changing the battery, pry the battery out of the holder with a sharp object.
, After changing the battery, set the present time and day.
Note:
, Take care of the battery. Refer to pages on lithium battery precaution.
, The setting before installing the battery is not valid. When operating this unit without any settings, the strobe function
may not be operated.