- Mitsubishi Digital Electronics VCR User Manual

1 OPERATION

1 Setting the multi-print and photo-print menus

Setting multi-print and photo-print functions

1 Press the MENU button. Then, press the UP

or DOWN shift button to select “3. ADDITIONAL PUSH [ ]”.

3 Press the DOWN

shift button to select “MULTI : OFF/ON”. Then press the RIGHT shift button to select “ON” .

4 Set the multi-image type (2, 2s, 4 or 16) or photo print size.

, “MODE : SAME/DIFF/PHOTO” is displayed on the menu screen.

, “IMAGES : 2 / 2s/ 4/ 16” is displayed on the lower line.

, Set “MODE : SAME/DIFF/PHOTO” and “IMAGES : 2/2s/4/16 or CARD/3*4/5*5” menus.

, Refer to 1 MULTI PRINT and 2 PHOTO PRINT for the multi-image type.

2 Press the RIGHT

shift button to select “3. ADDITIONAL”.

1 Setting the SEPARATE function

5 Press the DOWN shift button to select “SEPARATE : OFF/ON” .

6 Press the RIGHT shift button to select “ON”.

1 Displaying the source image (image from the input signal)

7 Press the SET

SET

button.

, “CHANGE : OK/CANCEL” is selected.

, When changing the setting, select “CANCEL”.

8 Press the SET

SET

button.

, The MAIN MENU is displayed.

9 Press the SET

SET

button.

, “SAVE PRG 1/2/3” is selected.

, This menu is used to store the setting in any one of 3 programs (1, 2 or 3).

A Press the RIGHT

or LEFT shift button to select the program number 1, 2 or 3 to store the setting.

, The setting will be overlaid. In case of keeping the stored program, do not select the program No. in which the setting is

stored.

8. Printing Procedures (Special prints)