- Mitsubishi Digital Electronics VCR User Manual

8. Printing Procedures (Special prints)

3 Set the “PAGE INC” to “ON”.

Set the “PAGE INC : ON/OFF” to “ON” in “6. SYSTEM” from the MAIN MENU.

4 Set the “MEM&PRINT” to “ON”.

Set the “MEM&PRINT : OFF/ON” to “ON” in “2. KEY SETTING” from the MEMORY SW MENU.

Displaying the source image (image from the input signal)

1 Press the SET

SET

button.

, “CHANGE : OK/CANCEL” is selected.

, When changing the setting, select “CANCEL”

2 Press the SET

SET

button.

, The MAIN MENU is displayed.

3 Press the SET

SET

button.

, “SAVE PRG 1/2/3” is selected.

, This menu is used to store the setting in any one of 3 programs (1, 2 or 3).

4 Press the RIGHT

or LEFT button to select the program number 1, 2 or 3 to store the setting.

, The setting will be overlaid. In case of keeping the stored program, do not select the program No. in which the setting is

stored.

5 Press the SET

SET

button.

, The source image (image from the input signal) is displayed.

Pressing the MEMORY button

Note :

1 Display the desired image for the automatic interval printing on the monitor.

2 Press the MEMORY button.

, The set automatic interval printing starts.

1 Interrupting automatic interval prints

, When the STOP button on the remote control is pressed, the automatic interval print is interrupted.

, “MEM&STOP” and “MEM&PRINT” function after the last image of the multi-image is stored in memory.

, Even if the number of prints is set to more than 1 at strobe print, STROBE is applied to the first page only.