- Mitsubishi Digital Electronics Switch User Manual

Extron • System 4
xixi
xixi
xi Switcher Series • User’s Manual • P/N 68-401-02 Rev. C
Configuration and Connections
Mitsubishi Installation
Page 5
6. Plug the 15-pin HD connector of the Projector Communications Extension cable
(shown as CC 50') into the PJ Comm port on the System 4xi. The other end
plugs into the other 9-pin male D connector on the Comm Adapter (mentioned in
Step 5).
______ Secure all of the connector screws.
7. Plug the (4 or 5) BNC connectors from one end of the (user-supplied) RGBS/HV
cable onto the System 4xi output and those on the other end onto the matching
BNCs on the Mitsubishi VS projector connector panel. See connection diagram
below.
System 4
xixi
xixi
xi Series – Mitsubishi VS Projector Connections
Use the illustration below as a guide when connecting the System 4xi to a
Mitsubishi VS projector. Refer to Mitsubishi VS documentation to continue the
installation.
____________ In a rack mount, do NOT allow the weight of the cables to be supported by the
System 4 xi . See page 2-5 for cabling guidelines.
__________ System 4 xi channel numbers correspond to the projector’s “Group” numbers.
26-473-01
"E"
"E"