- Mitsubishi Digital Electronics Graphic Operation Terminal Hardware Manual

Installation, Wiring and General Specifications 2.
2-1
2. Installation, Wiring and General Specifications
This section describes installation of the GOT and wiring of the power supply.
2.1 Installation of main body
Caution on installation
• Use the unit in the environment for the general specifications described in the manual.
Never use the unit in a place with dusts, soot, conductive dusts, corrosive gas or flamma-
ble gas, place exposed to high temperature, condensation or wind and rain or a place
subject to vibrations or impacts.
If the unit is used in an unfavorable place described above, electrical shock, fire, malfunc-
tion, damages of the unit or deterioration of the unit may be caused.
• Never drop cutting chips and wiring chips into the ventilation window of the graphic oper-
ation terminal when you drill screw holes or perform the wiring work.
Fire, failure or malfunction may be caused.
• Connect a connection cable and mount an extension module securely to the specified
connectors respectively while the power is turned off.
Imperfect connection may cause malfunction.
F940GOT-SWD-E/LWD-E