- Mitsubishi Digital Electronics VCR User Manual

O TurntheRFconverterOFFbyfollowinginstructionsonp.55.
Settingup your VCR if youare usinga TV withoutAudioand Video
Inputs(OlderTV)
If you are using an Older TV tA TV that does not have separate
Audio and Video inputs), then your VCR will need to "convert" the
VCR's picture or menus into a channel, this channel can be either
channel 3 or channel 4. The factory has alrea,Jy selected channel
3, however, if channel 3 is a real channel in y_ur area, then you
will need to change this to channel 4.
O
If you need to use channel 4, then before you turn on tlhe
VCR, press the CHANNEL/_ button and the ONE KEY
PROGRAM button on the front panel at the same time. The
words "Ant ch4" will be displayed on the J_ont panel and the
VCR will be reset to chan:ael 4.
_Important:
Turn the VCR on by pressing the POWEP button.
The VCR will return to its initial setting (channel 3) if you press
the CHANNEL _/button and the ONE KEY PROGRAM button
on the front panel at the same time with the VCR turned off. The
word "Ant ch3" will be displayed.
Usingthe RemoteControl
In this section, you'll learn how to set up and use your remote
control. This section includes:
• Using the remote control to operate the VCR, and
• Using the remote control to operate the TV.
Usingthe remotecontrolto operatethe VCR
installingthe batteries
0
e® 0
Unpack two AAA size batteries.
To remove the back cover:, press the ridged area gently, then
push the cover in the direction of the arrow and lift.
Load the batteries, making sure the polarities (+) and (-) are
correct.
operatingtheremotecontrol
The HS-U430 has two VCR operation modes: VCR-A mode and
VCR-B mode. The HS-U430 is pre-set to VCR-A operation mode.
O Set the TV/VCR slide swir.ch on the remote control to VCR
position. This "tells" the remote that you want to control the
VCR.
19