- Mitsubishi Digital Electronics VCR User Manual

Chapter3:OperatingYourVCR Usin9 theRemoteControl(cont.)

[_Important:

O Press the DISPLAY button and the number button "1" on the

remote control at the same time. Now your remote is ready to

operate your HS-U430.

O While within 23 feet of the VCR, point the remote control

toward the VCR and press the buttons you desire.

usingoneremoteto operatetwoMitsubishiVCRs

If you have another Mitsubishi VCR (from 1986 or later) in

addition to this HS-U430, you can use the HS-U430 remote

control to operate both VCRs. There are two separate remote

control signal systems available with this remote. One is "VCR-A"

which can be used to operate all Mitsubishi VCRs introduced in

1986 and later. The other signal system is %rCR-B" which will

operate the HS-U430 and selected other Mit:_ubishi VCRs.

To operate the two different VCRs separately (only one VCR

responding at a time) with the same remote, you need to program

one VCR to respond to VCR-A signals and the other VCR to

respond to VCR-B signals.

Since all Mitsubishi VCRs since 1986 and la_er will respond to

VCR-A signals, then you shonld program th_ HS-U430 to respond

to VCR-B signals, and you also will need to program the remote

control to send VCR-B signals. Use the following procedures:

Make sure the HS-U430 is plugged in b_.t turned off. On the

front panel of the VCR, press the ONE, I_:EY PROGR/_2VI and

the REW buttons at the same time (the letter "b" will appear

on the front panel display to confirm thi,; setting). The

HS-U430 VCR will now respond to VCR-B signals only.

On the remote, make sure the TV/VCR slide switch is; in the

VCR position, then press the DISPLAY and number _2"

buttons at the same time. The remote control will now send

VCR-B signals.

To operate the other VCR, you need to reprogram the remote

to send VCR-A signals again. With the 2V/VCR slide switch

in the VCR position, press the DISPLAY and the number "1"

buttons at the same time. The remote will now send VCR-A

signals.

To reprogram the HS-U430 r_orespond to VCR-A signals again,

use the following procedures:

Make sure the HS-U430 is plugged in but turned off. On the

front panel of the VCR, press the ONE KEY PROGI_kM and

the FF buttons at the same time (the ].etter "A" will appear on

the front panel display to confirm this setting). The HS-U430

VCR will now respond to VCR-A signals only.

Some other models of Mitsubishi VCRs can respond to VCR-B