- Mitsubishi Digital Electronics VCR User Manual

Chapter3: OperatingYourVCR Usingthe RemoteControl(cont.)
E>Important: When you replace the batteries in your remote, the remote will
return to its initial setting (code button "1"). Repeat the steps on
the previous page to reset your remote control. If you enter a new
code, the previous code will be erased.
operatingyourTVwiththe HS-U430remotecontrol
O Set the TV/VCR slide switch to TV position on the HS-U430
remote control.
_>Important:
O Point the remote control towards the rer_ote sensor on the TV
and press the desired buttons.
To once again control the VCR, set the TV/VCR slide switch to
VCR position.
Because of variations among models, some o1"all buttons may not
work, or they may operate different function:; than expected, for
your particular TV. If this occurs, you may n_ed to use your TV
remote control.
€ ViewingthePictureComingfrom YourVCR
This is the most important part of using you:._VCR, but often the
most confusing: how do you view a picture coming from the VCR?
Before you begin, you should know:
• whether you are viewing a "Modern TV" or an "Older TV'.
(See pages 18-19.)
Viewingthe picturecomingfrom your VCR if you are usinga
modernTV
_>Important:
_>Important:
0
Turn on your TV and swatch it to the correct external input.
(For most Mitsubishi TVs, this means pressing the TV's
INPUT button until you see the words "Ext-l" or "Input-l" on
the screen.)
Turn the VCR on by pressing the POWER button.
You are viewing the picture :from your VCR! If you wish to return
to normal TV viewing, switch your TV's input back to its previous
position.
If you are using a modern TV, be sure to set. the "RF converter" of
the "Customize choices" mer._u to OFF to prevent noise in the
picture.
If your system includes a home theater rece:Lver or an A/V
receiver, refer to your home theater receiver's owner's guide.
Viewingthe picturecomingfrom your VCR il you are usingan
olderTV
O Turn on your TV and tune it to channel 3 or 4.
22