- Mitsubishi Digital Electronics VCR User Manual

_Important:

Whenyouarefinished with all programming, be sure the

VCR power is OFF and the programmed recording light is lit.

However, if you have a cable box, leave iLturned ON .and

tuned to the station you wish to record. Additionally, if you

are using an A/B switch, remember to set the switch to the

correct position.

If you press the QUICK PROGRAM button, but the clock is not

set, you will see the "Set the clock" menu.

Notesabout programmedrecording

If you want to use the VCR before programmed recording begins,

press the POWER button on the remote once. This turns the

programmed recording light off and the VCR on.

If you use the POWER button on the front panel for this purpose,

you will have to press it twice. Pressing it once turns offthe

programmed recording light; pressing it a second time turns the

VCR on.

When you are finished using the VCR, turn t:he VCR power off

again, either with the POWER button on the remote or the

POWER button on the front panel. Make sure the programmed

recording light is back on.

After a program has been recorded, the VCR memory is cleared

(unless you have scheduled the VCR to record the program every

day or every week).

If there is already a program in the VCR's memory, you will see

the "recap" screen when you bring up the menus for programming

to record (unless you are programming with the QUICK PRO-

GRAM button). If the VCR's memory is full, you must erase a

program before you can enter a new one.

If a tape runs out during programmed recording, the VCR ejects

the tape and the programmed recording light and the tape status

symbol will flash. Load a new tape and press l:he REC button. The

VCR will resume recording. Do not overlap th_ recording times

you program.

Remember that when your VCR is off, it may also be in stand-by

for programmed recording. Also remember that the VCR, when

programmed, will record over the next section of tape. So, to avoid

recording over tapes you want to save, remember that the VCR

automatically shuts off during OTR recording and auto power

saving.

Your VCR will not record over a tape that has the erasure preven-

tion tab removed (see "Preventing accidental erasure"). All rental

movies have this tab removed, so they are safe from being acci-

dentally erased.