- Mitsubishi Digital Electronics VCR User Manual

High speed search >
Speed search > /
uic ,e.
Press REW button Playback
1/5 slow-motion playback
1/10 slow-motion playback
1/30 slow-motion playback ,_
Stiil I
1/30 reverse slow-m-_on playback I .i
1/10 reverse slow-motion playback .._ /
1/5__ -- / /
--[-" / Press FF button
Reverse fast playback I
Reverse speed search I
Reverse high speed search J "
DImportant: Depending on the type of TV you are using, the picture may
vibrate vertically when you pause the VCR's picture.
usingstilladjustment
Sometimes during still frame, the picture may vibrate or ,;hake.
To correct this problem, pres,,_ the CHANNEL buttons on the front
panel until the vibration is reduced or stops. (Side-to-side vibra-
tion cannot be corrected.)
usingthe two timesplaybackwithsound
You can see the contents of the videotape in double speed play-
back with Hi-Fi sound. Two times playback with sound is avail-
able only if your tape was recorded in extended (EP) speed. To do
this:
O While the VCR is playing a tape, press tile INPUT button on
the remote control. You'll see the picture in double speed
playback. A certain amount of"noise" in the picture or the
sound is normal.
_Important:
To resume normal playback, press the PLAY/STOP button.
If you are playing back a tape recorded in standard (SP) speed,
the sound is muted. You cannot hear the sound if you set the
audio monitor to "Mono" or if' the tape was recorded on a mono
VCR.
Adjustingthe tracking
D (digital tracking) light
I
[ °
II .111 II II sP_-p_
I_1.1 I IMII I.Is
automatictracking
Your VCR automatically adjusts the tape to _ve you the best
quality picture. When you press the PLAY/STOP button to start
playback, the D (digital trac_dng) light will £ash, showing that
the VCR is adjusting the picture. When the VCR has finished
adjusting the picture, the D light will shine ,;teadily.
47