- Mitsubishi Digital Electronics VCR User Manual

Chapter4:UsingtheAdvancedFeatures
Makinga CopyofaTape
There are two basic ways to make a copy of a tape. One way is to
use the HS-U430 to play a tape and use another VCR to record.
The other way is to use another VCR to play a tape and the
HS-U430 to record.
Whichever method you choose, you will need one RCA audio cable
and one RCA video cable to connect the two VCRs. If you do not
have these cables, they are available at your local electronics
retailer. In this section you'll learn:
• Using your HS-U430 to record from another VCR, and
• Using your HS-U430 to play back to another VCR.
UsingyourHS-U430to recordfrom anotherVCR
HS-U430 IRECORDING I [ PLAYBACK J
III
VIDEO ,N4_ _AUDIO IN R
--AUDIO IN IJMONO
mlm mmmmm
tit
Auo,o OUT
AUDIO OUT L-tjJ
O Connect one RCA audio cable to the AUDIO O
OUTPUT terminal on the other VCR.
Connect the other end of this cable to the
AUDIO INPUT terminal on the HS-U430
(labeled L/MONO). If the other VCR is
mono, this is the only audio connection
necessary.
°If the other VCR has stereo outputs, con-
nect another RCA audio cable to the AU-
DIO OUTPUT terminal of the playback
VCR. Connect the other end of this cable to
the AUDIO INPUT terminal on the
HS-U430 (labeled R).
e Connect a video cable to the VIDEO OUT-
PUT terminal on the playback VCR. Con-
nect the other end of this cable to the
VIDEO INPUT terminal on the HS-U430
(labeled VIDEO IN).
O If the other VCR is a Hi-Fi deck, set the
audio monitor to "STEREO."
56
O
O
O
O
If you attached the connection cables to the
back of the HS-U430, use the INPUT
button to set the HS.U430 to External 1
(L1). If you attached the cables to the front
of the HS-U430, use the INPUT button to
set the HS-U430 to Exl;ernal 2 (L2).
Put a blank tape into the HS-U430 and find
where you want to beg:n recording. Press
PLAY/STOP.
Put the tape you want to copy into the other
VCR and find the place, from which you
want to begin copying. Press STOP.
On the HS-U430, press REC, then PAUSE.
On the other VCR, press PLAY, then
PAUSE.
_) Release the PAUSE button on both VCRs at
the same time.
When finished, press; t:'LAY/STOP (or
STOP) on both VCRs.