user manual

Bulletin Number Chapter 7: Appendix 91 of 102

Customer Setup Menu

Units

This screen allows the user to change the blender’s unit of measurement. The entire blender

can be configured in either Kgs. or Lbs., while the Target vs. Actual data can be configured

for either regardless of the blender’s units.

Figure 73: Typical Units Screen

Network Setup

This screen allows the blender to be configured for use with the Ethernet Option. The

blender will automatically configure the Ethernet module’s IP Address and Subnet Mask if

the configurator is enabled. Whenever you modify the IP Address or subnet, you either need

to reboot the PLC.

Figure 74: Typical Ethernet Setup Screen

Change Target vs.

Actual Units

Change

Blender’s

Units

Go back to

Setup

Director

Go back to Setup