1.
L 2. Installation # Install on a completely flat and rigid surface. # Using the two front adjustable fest, ensure that the refrigerator is positions firmly and level on the orifice. Now ops the doors approximately half way, and extend the front adjustable feet equally until the doors close by themselves. Toe Grille Yt Leveling Leg + To ensure adequate ventilation for your refrigerator, spaces of 20mm on both sides, 50mm at the rear, and 100mm above the refrigerator are recommended.
L 3. Electrical Connections Important: For personal safety, this appliance must be properly grounded. « The refrigerator should always be plugged into its own individual electrical outset. This is recommended for best performance and also in order to prevent the overloading of household wiring consults, which may cause a fire hazard. Extension cords are not recommended. Marks sirs that the outset provides the comet voltage. o If your refrigerator has a grounding plug, use it comely.
L 4, Sliding Case o This sliding case Is cooled to a low temperature In order to preserve the freshness of foods stored for long periods. Lid & Open by pulling the case out. i CAUTION: Ba fore closing the refrigerator compartment door, make sure that the sliding case Is pushed all the way In (and the Ild Is closed correctly). o Remove the Iid and sliding case as shown In the illustration and proceed with cleaning. * Pull the case out.
L 6. How to Remove the Pockets (1) Push the button inside of door panel. (2)Lift up the pocket and pull out to the front side. FREEZER POCKET FREE POCKET ® BOTTLE POCKET Flexible glass shelf » To store large or tall kens (1) Remove all food Isms from the Flexible Shelf. (2) Press down the Rear Shelf then pull the Front Shelf out, then the Front Shelf can be separated from the Rear Shelf.
L 8. Elevating shelf Move the lever on the front of the shelf left or right to adjust the shelf to the desired position. Move the lever to the right to raise the shelf. Move the lever to the left to lower the shelf. o The lever will be difficult to move when heavy items are placed on the shad. « When the elevating shelf is lowered, one of the shelf supports may come off if the half contacts any foods under the shelf. This is to prevent damaging the food.
L 5. Maintenance When performing maintenance, make absolutely sure that the power plug Is first disconnected from the power outlast. # Dip a soft cloth into cold or lukewarm water, wring it out well and weeps. o If you do not clean the door gasket (especially the lower part} when it is dirty, the gasket will easily become damaged. Therefore, keep it clean at all times. ® Do not clean with cleanser, acids, benzine, thinner, boiling water, soap powder, chemical cloths or neutral detergent.
L @ Push up each support, one at a time, with a strong effort. (4 supports) (When the Internal hooks are released from the refrigerator, a “click” sound will be heard.) If the supports are not released easily, push the internal () After the 4 supports are released, pull out the shelf. 4. How to remove the tray forward the hooks (3) at the back (1) Push the tray upward while pulling of the shelf with your finger. /7“ Lift up the back of the tray until the front hooks (4) are released.
L 6. Safety Advice The suggestions below apply to the operation of your home electric refrigerator. Mitsubishi Electric Corporation recommends these safety precautions. If your old refrigerator is sill in your house but not in use, ba sure to remove the door(s). This will ensure that children will not get frappes inside. Neva unplug your refrigerator by pulling on the cord. Airways take hold of the plug firmly and pull it straight out of the socket.
L ‘When the refrigerator is not cooling sufficiently The food may be packed too tightly together, which blocks the flow of cool air. You may have put hot or too many items into the refrigerator. The door may not have bun closed properly. The door gasket may be damaged. The refrigerator may not be well-ventilated. There may be insufficient clearance between the refrigerator and the surfaces immediately aside and above. The temperature control dial may not be properly set.
L MITSUBISHI ELECTRIC CORPORATION HEAD OFFICE : TOKYO BUILDING 2-7-3, MARASCHINO, CHIYODA-KU, TOKYO 100-8310, JAPAN PHONE: +81 (3) 3218-2111 MitsubishiElectric.com Distributed by: MITSUBISHI ELECTRIC AUSTRALIA PTY LTD. (Incorporated in New South Wales) ABN 58 001 215 792 New South Wales: 348 Victoria Road, Chalmers NSW 2116 Ph: (02) 9684 Fax: (02) 9898 0484 Queensland: Unit 12, 469 Nudge Road.
