Owners Manual

3. Push the connector (C) to disconnect and re-
move the fog lamp.
4. Remove
the entire socket and bulb assembly
(D) by turning it anticlockwise.
5. To
install the bulb, perform the removal
steps in reverse.
NOTE
l
When
mounting the lamp unit, align the
holes in the lamp unit with the pins (E) on
the vehicle body.
CAUTION
l
Handle
halogen lamp bulbs with care.
The gas inside halogen lamp bulbs is high-
ly pressurized, so dropping, knocking, or
scratching a halogen lamp bulb can cause
it to shatter.
l
Never hold the halogen lamp bulb with a
bare hand, dirty glove, etc.
The oil from your hand could cause the
bulb to break the next time the fog lamps
are operated.
If the glass surface is dirty, it must be
cleaned with alcohol, paint thinner, etc.,
and refit it after drying thoroughly.
Rear combination lamps
E01004201382
3-door models
1. Remove
the screws (A) (2 locations), and
then remove the lamp unit.
Maintenance
8-27
8
Presented by http://mmc-manuals.ru/ ©