Owners Manual

NOTE
l
Be
sure to perform the procedure with the
MITSUBISHI mark facing you. If the
MITSUBISHI mark is not facing you when
you open the remote control switch case, the
switches may come out.
4. Remove the remote control transmitter from
the remote control switch case. Then, open
the remote control transmitter using the meth-
od described in step 2.
5. Remove the old battery.
6. Install a new battery with the + side (B) down.
Coin type battery
CR1616
- side
+ side
7. Close the remote control transmitter firmly.
8. Place the remote control transmitter in the re-
mote control switch case, then securely close
the remote control switch case.
9. Attach the screw (A) removed in step 1.
10. Check the keyless entry system to see that it
works.
NOTE
l
You may purchase a replacement battery at
an electric appliance store.
l
A MITSUBISHI MOTORS Authorized Serv-
ice Point can replace the battery for you if
you prefer.
CAUTION
l
When
the remote control switch case is
opened, be careful to keep water, dust,
etc. out. Also, do not touch the internal
components.
Doors
E00300402187
CAUTION
l
Make
sure the doors are closed: driving
with doors not completely closed is dan-
gerous.
l
Never leave children in the vehicle unat-
tended.
l
Be careful not to lock the doors while the
key is inside the vehicle.
NOTE
l
To
prevent the key from being locked inside
the vehicle, neither the lock knob on the driv-
er’s door nor the key can be used to lock the
driver’s door when it is open.
To lock or unlock with the key
1- Lock
2-
Unlock
Locking and unlocking
2-05
2
Presented by http://mmc-manuals.ru/ ©