Owners Manual

ManualsBrandsMITSUBISHI ManualsAutomotiveMitsubishi L200 2011 Owners Manual.pdf

201

202

203

204

205

206

207

208

209

210

NOTE

the TUNE/SEEK button (3

or 4) is pressed

for more than 1 second, the radio will try to

find out another broadcast of the same pro-

gram type as currently selected.

If no station is found with your desired PTY,

the display will show “EMPTY” for about

5 seconds and the radio will return to the pre-

vious station.

How to enter PTYs in the memory

E00721400135

As many as 6 PTYs can be entered in the memory.

Follow the steps described below.

1. Press

either the TUNE/SEEK button

(3 or 4)

to tune the PTY to be entered in the memory.

2. Press one of the memory select buttons (2)

for 2 seconds or longer. The number of the

button corresponding to the entry into the

memory and the PTY are displayed.

3. The preset memory setting is retrieved by

pressing the button and then releasing it with-

in about 2 seconds.

Traffic information

E00721600254

The radio will automatically tune in to traffic infor-

mation broadcasts while receiving FM

broadcasts

or playing compact discs etc.

To select this function, follow the instructions below.

1. Press the TP button (6). The display will

show “TP” (13). If the RDS data can be read,

the display will show “RDS” (9). If not, the

display will show “NO RDS” for about 5 sec-

onds.

2. If the radio detects traffic information on ei-

ther the station currently

selected or another

station, the display will show “TRAF INF”

for 5 seconds followed by a 2-second indica-

tion of the frequency. Then, it will show the

name of the station broadcasting the traffic in-

formation to which you will listen. The vol-

ume level is set separately for listening to nor-

mal audio programs and for listening to traf-

fic information. The volume level will there-

fore change automatically to that set when

traffic information was last received. When

the traffic information broadcast is over, the

radio will return to the previously received

program and to the corresponding volume lev-

el.

3. Press the TP button (6) to return to the previ-

ous condition.

NOTE

While “TP” is illuminated, the radio stops on-

ly at TP stations even if the TUNE/SEEK but-

ton (3 or 4) is pressed.

TP (Traffic information Program) search function

E00721800168

The traffic information program standby function

turned

(with

the

TP indicator (13) shown on

the display) and after about 45 seconds since the

RDS indicator (9) turns off due to weak signal or

the tuning station is changed over from a TP sta-

tion to a station which does not broadcast traffic in-

formation, and seeks out a TP station in all frequen-

cies automatically.

The TP search function can be turned ON and OFF.

Refer to “Function setup mode” on page 5-21.

For pleasant driving

5-20

OCRE12E1