Owners Manual

ManualsBrandsMITSUBISHI ManualsAutomotiveMitsubishi L200 2011 Owners Manual.pdf

231

232

233

234

235

236

237

238

239

240

Speaker enrollment

E00727500196

It takes about 2 to 3 minutes to complete the speak-

er enrollment process.

To ensure the best results, run through the process

while in the driver’s seat, in an environment that is

as quiet as possible (when there is no rain or strong

winds and the vehicle windows are closed). Please

turn off your phone while in speaker enrollment to

prevent interruption of the process.

Use the following procedure for speaker enrollment.

1. Stop your vehicle in a safe area, put the gear-

shift lever in the “N” (Neutral) position

(M/T), or the selector lever in the “P”

(PARK) position (A/T), and pull the parking

brake lever.

NOTE

Speaker enrollment is not possible unless the

vehicle is parked. Make sure you park the ve-

hicle in a safe area before attempting speaker

enrollment.

2. Press the SPEECH button.

3. Say “Voice training”.

4. The voice guide will say “This operation

must be performed in a quiet environment

while the vehicle is stopped. See the owner’s

manual for the list of required training phra-

ses. Press and release the SPEECH button

when you are ready to begin. Press the HANG-

UP button to cancel at any time”.

Press the SPEECH button to start the speaker

enrollment process.

NOTE

you do not start

the speaker enrollment proc-

ess within 3 minutes of pressing the

SPEECH button, the speaker enrollment func-

tion will time out.

The voice guide will say “Speaker Enroll-

ment has timed out”. The system will then

beep and the voice recognition mode will be

deactivated.

5. The voice guide will prompt for phrase 1. Re-

peat the corresponding phrase listed in table

“Enrollment commands” on page 5-66.

The system will register your voice and then

move on to the registration of the next com-

mand. Continue the process until all phrases

have been registered.

NOTE

To repeat the most recent voice training com-

mand, press and release the SPEECH button.

If you press the HANG-UP button anytime

during the process, the system will beep and

stop the speaker enrollment process.

6. When all enrollment commands have been

read out, the voice guide will say “Speaker

enrollment is complete”. The system will

then end the speaker enrollment process and

return to the main menu.

NOTE

Completing the speaker enrollment process

will turn on the voice model automatically.

The commands “Help” and “Cancel” will not

work in this mode.

Enabling and disabling the voice model and re-

training

E00727600096

You can turn a voice

model registered with the

speaker enrollment function on and off whenever

you want.

You can also retrain the system.

Use the following procedure to perform these ac-

tions.

1. Press the SPEECH button.

2. Say “Voice training”.

3. If you have completed a speaker enrollment

process once already, the voice guide will

say either “Enrollment is enabled. Would

you like to disable or retrain?” or “Enroll-

ment is disabled. Would you like to enable

or retrain?”

4. When enrollment is “enabled”, the voice mod-

el is on; when enrollment is “disabled”, the

voice model is off. Say the command that

fits your needs.

Say “Retrain” to start the speaker enrollment

process and recreate a new voice model. (Re-

fer to “Speaker enrollment” on page 5-55.)

Connecting the Bluetooth

2.0 inter-

face and Bluetooth

device

E00760600204

Before you can make or receive hands-free calls or

play music using the Bluetooth

2.0 interface func-

tion, you must pair the

Bluetooth

device and Blue-

tooth

2.0 interface.

For pleasant driving

5-55

OCRE12E1