Owners Manual

E- Rear jacking point
WARNING
l
Set the jack only at the positions shown
here. If the jack is set at a wrong position,
it could dent your vehicle or the jack
might fall over and cause personal injury.
l
Do not use the jack on a tilted or soft sur-
face. Otherwise, the jack might slip and
cause personal injury. Always use the
jack on a flat, hard surface. Before set-
ting the jack, make sure there are no
sand or pebbles under the jack base.
NOTE
l
When
jacking up the rear
of the vehicle, turn
the tip of the jack so that the grooved portion
(F) properly meets the designated point.
To raise the vehicle
1. Using the jack handle, turn
the release valve
(G) clockwise until it stops.
2. Insert the jack handle in the bracket of the
jack and hook the
notch (H) on the jack han-
dle end to the claw (I) of the bracket.
3. Move the jack handle up and down to raise
the ram until just
before the jack contacts the
jacking point of the vehicle. Ensure that the
jack will properly contact the vehicle jacking
point.
Move the jack handle up and down to raise
the vehicle.
NOTE
l
This jack is a 2 stage expansion type.
To lower the vehicle
1. Put
the notch (J) provided
on the jack handle
end on the valve (K) of the jack.
For emergencies
6-14
6
OCRE12E1
Presented by http://mmc-manuals.ru/ ©