Owners Manual

RHD
4. Referring to the fuse load
capacity table,
check the fuse pertaining to the problem.
C- Fuse is OK
D- Blown fuse
NOTE
l
If
any system does not
function but the fuse
corresponding to that system is normal, there
may be a fault in the system elsewhere. We
recommend you to have your vehicle checked.
5. Insert
a new fuse of the same capacity by us-
ing the fuse puller
into the same place at the
fuse block.
CAUTION
l
If the newly inserted fuse
blows again af-
ter a short time, we recommend you to
have the electrical system checked to find
the cause and rectify it.
l
Never use a fuse with a capacity larger
than that specified or any substitute, such
as wire, foil, etc.; doing so will cause the
circuit wiring to heat up and could cause
a fire.
Replacement of lamp bulbs
E01003100710
Before replacing a bulb, ensure
the lamp is off. Do
not touch the glass part of the new bulb with your
bare fingers; the skin oil left on the glass will evap-
orate when the bulb gets hot and the vapour will
condense on the reflector and dim the surface.
CAUTION
l
Bulbs are extremely hot immediately
af-
ter being turned off.
When replacing a bulb, wait for it to cool
sufficiently before touching it. You could
otherwise be burnt.
NOTE
l
If
you are unsure of
how to carry out the
work as required, we recommend you to con-
sult a specialist.
l
Be careful not to scratch the vehicle body
when removing a lamp or lens.
l
When it rains or when the vehicle has been
washed, the inside of the lens sometimes be-
comes foggy. This is the same phenomenon
as when window glass mists up on a humid
day, and does not indicate a functional prob-
lem. When the lamp is switched on, the heat
will remove the fog. However, if water gath-
ers inside the lamp, we recommend you to
have the lamp checked.
Bulb capacity
E01003200085
When replacing a bulb, use a new bulb with the
same wattage and colour.
Maintenance
8-23
8
OCRE12E1
Presented by http://mmc-manuals.ru/ ©