Owners Manual

Central door locks*

E00300801504

NOTE

Each

of the doors can

be locked or unlocked

independently by using the inside lock knob.

Repeated continuous operation between lock

and unlock could activate the central door

locking systems built-in protection circuit

and prevent the system from operating. If

this occurs, wait about 1 minute before oper-

ating the inside lock knob or the key.

All of the doors can be locked and unlocked as de-

scribed hereafter.

Driver’s door with key

Turn the key in the driver’s door towards the front

of the vehicle to lock the doors and towards the

rear of the vehicle to unlock the doors.

1- Lock

2- Unlock

Driver’s door with inside lock knob

Set the inside lock knob

on the driver’s door to-

wards the front of the vehicle to lock the doors. Set

it towards the rear of the vehicle to unlock the doors.

1- Lock

2- Unlock

Unlocking doors using selector lever

(vehicle with keyless entry system)

It is possible to unlock all of the doors using the se-

lector lever by placing in the “P” position while the

ignition switch is in the “ON” position.

NOTE

The

vehicle is shipped from

the factory with

a setting established such that the doors are

not unlocked when the selector lever is

placed in the in the “P” position with the ig-

nition switch in the “ON” position. If you

wish to change the setting such that the doors

are unlocked, contact your MITSUBISHI

MOTORS Authorized Service Point.

Locking and unlocking

1-07

OCRE12E1