Owners Manual
When the lever or pedal is used, the seatback will
tilt forward and at the same time the entire seat will
move forward. To return the seat, slide the entire
seat rearward and then raise the seatback rearward
to lock the seat in position.
WARNING
l
Do not drive the vehicle with the seatback
folded forward. The seat is
not retained
position if it is not kept in an upright posi-
tion, so serious injuries could be suffered
in the event of hard braking or a collision.
CAUTION
l
The reclining mechanism of the seatback
is spring loaded, causing it to return to
the vertical position when the lock lever
is operated. When using the lever, sit
close to the seatback or hold it with your
hand.
l
Use a foot to operate the pedal (2).
Folding the seatback forward (Single
cab, passenger’s seat)*
E00410400031
To access the onboard tool kit, fold forward the seat-
back of the passenger’s seat.
Refer
to “Tools, jack and
jack handle” on page
6-07.
Pull the band and fold the seatback forward.
Heated seats*
E00401100784
The heated seats can be operated with the ignition
switch in the “ON” position.
1 (HI)- Heater high (for quick heating).
2- Heater off.
3 (LO)- Heater low (to keep the seat warm).
The indication lamp (A) will illuminate while the
heater is on.
CAUTION
l
Switch off seat heaters when not in use.
l
Operate in the high position for quick heat-
ing. Once the seat is warm, set the heater
to low to keep it warm. Slight variations
in seat temperature may be felt while us-
ing the heated seats. This is caused by the
operation of the heater’s internal thermo-
stat and does not indicate a malfunction.
l
If the following types of persons use the
heated seats, they might become too hot
or receive minor burns (red skin, heat blis-
ters, etc.):
• Children, elderly or ill people
• People with sensitive skin
• Excessively tired people
• People under the influence of alcohol
or sleep inducing medication (cold
medicine, etc.)
l
Do not place heavy objects on the seat or
stick pins, needles, or other pointed ob-
jects into it.
l
Do not use a blanket, cushion, or other ma-
terial with high heat insulation properties
on the seat while using the heater; this
might cause the heater element to overheat
l
When cleaning the seat, do not use ben-
zene, kerosene, petrol, alcohol, or other or-
ganic solvents; these might damage the
surface of the seat and also the heater ele-
ment.
l
If water or any other liquid is spilled on
the seat, allow it to dry thoroughly before
attempting to use the heater.
l
Turn the heater off immediately if it ap-
pears to be malfunctioning during use.
Seat and seat belts
2-06
2
OCRE12E1
Presented by http://mmc-manuals.ru/ ©