Service Manual

2-32
Seat and restraint systems
2
Installation
1. Place the child restraint system on the seat where you
wish to install it.
To help assure proper fitting of the child restraint system,
always remove the head restraint.
2. Route the seat belt through the child restraint system
according to the instructions provided by the child
restraint system’s manufacturer. Then insert the seat belt
latch plate into the buckle. Make sure you hear a “click”
when you insert the latch plate into the buckle.
3. To activate the ALR child restraint installation function,
slowly pull the shoulder part of the belt all the way out of
the retractor until it stops. Then let the belt feed back into
the retractor.
4. After the belt has retracted, tug on it.
If the belt is in the ALR function, you will not be able to
pull it out. If the webbing can be pulled out from retractor,
the ALR function has not been activated and you will
need to repeat steps 3 and 4.
BK0162600US.book 32 ページ 2013年3月22日 金曜日 午後2時41分