Service Manual

Features and controls
3-9
3
To lock
Press the LOCK button (1) to lock all the doors and the liftgate.
The turn signal lights will also blink once.
N
OTE
● If you press the LOCK button (1) twice the horn will
sound once.
To unlock
Press the UNLOCK button (2) to unlock the driver’s door only.
Within about 2 seconds, press the UNLOCK button one more
time to unlock all the doors and liftgate.
The dome light will turn on for 30 seconds. The turn signal
lights will also blink twice.
N
OTE
● The door and liftgate unlock function can be set so that all
doors and liftgate unlock when the UNLOCK button (2) is
pressed once.
Refer to “Setting of door and liftgate unlock function” on
page 3-10.
Answerback function
The horn of the keyless entry system answerback function can
be changed as required. This is done with the key removed
from the ignition switch.
N
OTE
● The answerback function will not operate if any of the
doors are open.
Horn deactivation/reactivation
The answerback function can be set in the following three
ways.
Each time the answerback function is set, a chime will sound to
tell you the condition of the answerback function.
1. Remove the key from the ignition switch.
2. Open the driver’s door and turn the combination head-
lights and dimmer switch to the “OFF” position.
3. Press the LOCK button (1) for 4 to 10 seconds and press
the UNLOCK button (2) during this time.
4. Release in sequence the UNLOCK and LOCK buttons
within 10 seconds of pressing the UNLOCK button in step
3.
Turn signal lights deactivation/reactivation
The turn signal lights answerback function can be changed.
If you want to change the answerback function, please contact
an authorized Mitsubishi Motors dealer.
One chime: The horn will not sound.
Two chimes: The horn will sound.
Four chimes: The horn will sound if the LOCK button is
pressed twice within 1 second.
BK0162600US.book 9 ページ ２０１３年３月２２日 金曜日 午後２時４１分