MY Owners Manual

Combination headlamps and dipper switch
6-42 Instruments and controls
6
 If the operation mode of the power switch
is put in OFF or ACC while the lamp
switch is in the “ ” or “ ” position,
the lamps will turn off automatically
when the driver"s door is opened.
 If the operation mode of the power switch
is put in OFF or ACC while the lamp
switch is in the “ ” or “ ” position,
the lamps will remain on for about 3 min-
utes while the driver’s door is shut and
will then automatically turn off.
1. Turn the lamp switch in the “OFF” posi-
tion while the operation mode of the
power switch is in OFF or ACC.
2. Turn on the lamps with the switch in the
“ ” or “ ” position again, then the
lamps will remain on.
3. When 1 minute has passed, the lamps will
automatically be turned off.
E00506101631
If the driver’s door is opened when the opera-
tion mode of the power switch is put in ACC
or OFF with the lamps illuminated, a buzzer
will sound to remind the driver to turn off the
lamps.
The buzzer will automatically stop if the
auto-cutoff function is activated, the lamp
switch is turned off, or the door is closed.
E00506201544
When the lamp switch is in the “ ” posi-
tion, the beam changes from high to low (or
low to high) each time the lever is pulled
fully (1). While the high beam is on, the high
beam indicator lamp in the instrument cluster
will also illuminate.
E00506300199
The high beams flash when the lever is pulled
slightly (2), and will go off when it is
released.
When the high beam is on, the high beam
indicator lamp in the instrument cluster will
illuminate.
Lamps (headlamps, fog lamp,
etc.) auto-cutout function
NOTE
 The lamp auto-cutout function can also be
disabled.
For further information, we recommend you
to consult a MITSUBISHI MOTORS
Authorised Service Point.
On vehicles equipped with Mitsubishi Multi-
Communication System (MMCS), screen
operations can be used to make the adjust-
ment. Refer to the separate owner’s manual
for details.
When you want to keep the lamps
on:
NOTE
 If you place the light switch in the “ ”
position, the lamps will not be automatically
turned off.
Lamp monitor buzzer
Dipper (High/Low beam
change)
Headlamp flasher
BK0203201EN.book 42 ページ ２０１３年１１月１９日 火曜日 午前１１時５０分