MY Owners Manual

Combination headlamps and dipper switch
Instruments and controls 6-43
6
E00528901600
This function turns on the position and tail
lamps for about 30 seconds after the
UNLOCK switch on the remote control trans-
mitter is pressed when the combination head-
lamps and dipper switch is in the “OFF” or
“AUTO” position (for vehicles equipped with
the automatic lamp control). On vehicles
equipped with the automatic lamp control
(except for vehicles equipped with LDW), the
welcome light function will operate only
when it is dark outside the vehicle.
E00529001549
This function turns on the headlamps in the
low beam setting for about 30 seconds after
the operation mode is put in OFF.
1. Turn the combination headlamps and dip-
per switch to the “OFF” or “AUTO” posi-
tion (for vehicles equipped with the
automatic lamp control).
2. Put the operation mode of the power
switch in OFF.
3. Within 60 seconds of putting the opera-
tion mode in OFF, pull the turn signal
lever towards you.
4. The headlamps will come on in the low
beam setting for about 30 seconds. After
the headlamps go off, the headlamps can
be turned on again in the low beam setting
for about 30 seconds by pulling the turn
signal lever towards you within 60 sec-
onds of putting the operation mode in
OFF.
To turn on the headlamps again after 60
seconds of putting the operation mode in
OFF, repeat the process from step 1.
NOTE
 The high beams can also flash when the lamp
switch is OFF.
 If you turn the lamps off with the headlamps
set to highbeam, the headlamps are automati-
cally returned to their low-beam setting
when the lamp switch is next turned to the
“” position.
Welcome light
NOTE
 While the welcome light function is operat-
ing, perform one of the following operations
to cancel the function.
•Push the LOCK switch on the remote con-
trol transmitter.
•Turn the combination headlamps and dip-
per switch to the “ ” or “ ” position.
•Put the operation mode of the power switch
in ON.
 It is possible to modify functions as follows:
•The headlamps can be set to come on in the
low beam setting.
•The welcome light function can be deacti-
vated.
For further information, please contact your
MITSUBISHI MOTORS Authorised Service
Point.
On vehicles equipped with Mitsubishi Multi-
Communication System (MMCS), screen
operations can be used to make the adjust-
ment. Refer to the separate owner’s manual
for details.
Coming home light
NOTE
NOTE
 While the coming home light function is
operating, perform one of the following
operations to cancel the function.
•Pull the turn signal lever towards you.
BK0203201EN.book 43 ページ ２０１３年１１月１９日 火曜日 午前１１時５０分