MY Owners Manual
Anti-lock brake system (ABS)
Starting and driving 7-31
7
E00607302423
Avoid hard braking and high-speed driv-
ing. Stop the vehicle in a safe place.
Restart the Plug-in Hybrid EV System
and check to see whether the lamp goes
out after a few minutes driving; if it then
remains off during driving, there is no
problem.
However, if the lamp does not go out, or if
it lights up again when the vehicle is
driven, we recommend you to have the
vehicle checked as soon as possible.
If you start Plug-in Hybrid EV System
when the auxiliary battery voltage is
insufficient, ABS warning lamp/display
may illuminate, but this is not a failure of
ABS. When the drive battery is charged,
the auxiliary battery is also charged, and
the warning lamp/display will go out. If
the warning lamp/display continues illu-
minating even after the battery is suffi-
ciently charged or the warning
lamp/display illuminates frequently ,have
your vehicle inspected by a MITSUBISHI
MOTORS Authorised Service Point.
Warning lamp
Warning display
The ABS and brake force distribution func-
tion may not work, so hard braking could
make the vehicle unstable.
Avoid hard braking a nd high-speed driving.
Stop the vehicle in a safe place immediately
and contact a MITSUBISHI MOTORS
Authorised Service Point.
E00618800219
After driving on snowy roads, remove any
snow and ice which may have become
adhered to the wheel areas.
When doing this, be careful not to damage the
wheel speed sensors (A) and cables located at
each wheel on vehicles equipped with an
ABS.
If the warning lamp / display
illuminate while driving
If only the ABS warning lamp/dis-
play illuminate
If the ABS warning lamp / display
and brake warning lamp / display
illuminate at the same time
NOTE
The ABS warning lamp and brake warning
lamp illuminate at the same time and the
warning displays appear alternately on the
information screen in the multi information
display.
After driving on icy roads
Front Rear
BK0203201EN.book 31 ページ 2013年11月19日 火曜日 午前11時50分