MY Owners Manual

Cruise control*
7-38 Starting and driving
7
E00609702434
The set speed driving can be deactivated as
follows:
 Press the CRUISE CONTROL ON/OFF
switch (A) (Cruise control will be turned
off.)
 Press the CANCEL switch (D).
 Depress the brake pedal.
The set speed driving is deactivated automati-
cally in any of the following ways.
 When your speed slows to about 15 km/h
or more below the set speed because of a
hill, etc.
 When your speed slows to about 40 km/h
or less.
 When the active stability control (ASC)
starts operating.
Refer to “Active stability control (ASC)”
on page 7-32.
E00609801731
If the set speed driving is deactivated by the
condition described in “To deactivate” on
page 7-38, you can resume the previously set
speed by push up the RES + switch (C) while
driving at a speed of about 40 km/h or higher.
The “SET” indicator appears on the informa-
tion display in the meter cluster.
Under either of the following conditions,
however, using the switch does not allow you
to resume the previously set speed. In these
situations, repeat the speed setting procedure:
 The CRUISE CONTROL ON/OFF
switch is pressed.
 The operation mode is put in OFF.
 Indicator display go off.
To deactivate
WARNING
 Although the set speed driving will be
deactivated when shifting to the “N”
(NEUTRAL) position, never move the
selector lever to the “N” (NEUTRAL)
position while driving.
You w oul d hav e n o regenerative brake
and could cause a serious accident.
CAUTION
 When the set speed driving is deactivated
automatically in any situation other than
those listed above, there may be a system
malfunction.
Press the CRUISE CONTROL ON/OFF
switch to turn off the cruise control and have
your vehicle inspected by a MITSUBISHI
MOTORS Authorised Service Point.
To resume the set s pe ed
BK0203201EN.book 38 ページ ２０１３年１１月１９日 火曜日 午前１１時５０分