MY Owners Manual

Adaptive Cruise Control System (ACC)*
Starting and driving 7-47
7
E00634801025
 The ACC makes neither acceleration nor
deceleration control and only issues warning
in the following situation.
•The vehicle in front is in a park or moving
at an extremely slow speed.
 The ACC may not be able to maintain the set
speed or the distance to a vehicle in front and
may not alert the driver, if the system cannot
detect the front vehicle properly in the fol-
lowing situations.
• When a vehicle enters in front of your vehi-
cle very closely.
•When a vehicle in front is offset to the left
or right.
•When a vehicle in front is towing a trailer.
•The vehicle in front is moving at a speed
much lower than your vehicle.
•A motorcycle or a bicycle.
•A freight trailer that is not carrying a con-
tainer.
•The vehicle has a protruding load from the
carrier.
•The vehicle has a low vehicle height.
•The vehicle has an extremely high ground
clearance.
•When there is repeated steep uphill and
downhill driving.
•When driving on an irregular or uneven
road surface.
•When being driven in a tunnel.
•When you are carrying extremely heavy
loads in the rear seats or luggage area.
CAUTION
•After the Plug-in Hybrid EV System start-
ing for a while.
•When driving in curved sections of road
including their entrance/outlet or running
beside a closed lane in a traffic work or
similar zone.
•When the cover part in front of the sensor
and the sensor become dirty or adhering
snow and ice*.
•When water, snow or sand on the road are
extorted by the vehicle in front or an
oncoming vehicle*.
*: After the ACC control has been cancelled
automatically due to detection of a state of
decline in performance, the ACC will not
operate in the temporary condition and will
inform the driver by buzzer and indication.
When the ACC is in the state in which it can
operate, indication is cancelled.
Should indications not cancel there is a pos-
sible abnormality in the system.
Please contact a MITSUBISHI MOTORS
Authorised Service Point.
CAUTION
Cruise control switch
1- “ACC ON/OFF” switch
Used to turn on and off ACC or the
cruise control function.
2- “SET -” switch
Used to set a desired speed and to
reduce the set speed.
3- “RES +” switch
Used to make ACC operate at the origi-
nally set speed and also to increase the
set speed.
4- “CANCEL” switch
Used to cancel the control function of
ACC or the cruise control.
5- ACC distance switch
Used to change the setting of the fol-
lowing distance between your vehicle
and a vehicle in front.
BK0203201EN.book 47 ページ ２０１３年１１月１９日 火曜日 午前１１時５０分