MY Owners Manual

Reversing sensor system*
Starting and driving 7-65
7
E00615701823
To operate the system, move the selector
lever to the “R” position while the operation
mode is put in ON. When the reversing sen-
sor system is operated, the reversing sensor
system operation indicator lamp (A) will turn
on. To stop the operation, push the “SONAR”
switch; the reversing sensor system operation
indicator lamp (A) is turned off.
If there is an obstacle behind the vehicle, a
warning will be issued with the information
screen in the multi information display and a
warning buzzer.
Corner sensor
• The vehicle tilts significantly.
•The vehicle is driven on a rough road (with
a bumpy, gravel, hilly, or grassy surface).
•The vehicle is too close to an obstacle.
•The sensors or surroundings have been
wiped by hand, or stickers or accessories
have been attached.
 The reversing sensor system may not prop-
erly detect the following:
•Objects that are thin, such as wire nets or
ropes.
•Objects that absorb sound waves, such as
snow.
•Objects that are shaped with a sharp angle.
•Objects with a smooth surface, such as
glass.
•Objects that are low, such as kerbstones.
NOTE
 The buzzer may sound lower than the normal
warning sound when the reversing sensor
system is receiving ultrasonic noise from
other sources, but this is not a malfunction.
The buzzer will stop sounding and the sys-
tem will return to normal operation after the
noise is no longer received.
CAUTION
To operate
NOTE
 Only when the select position is the “R”
position, the reversing sensor system can be
operated or be stopped by using the
“SONAR” switch.
Warning for obstacles
1- Corner sensor (left)
2- Back sensor
3- Corner sensor (right)
Veh i c l e to o bstacl e
distance
Warning dis-
play/sound cycle
Approx. 60 to 40 cm Intermittent
Approx. 40 to 20 cm Fast intermittent
Within approx. 20
cm
Continuous
BK0203201EN.book 65 ページ ２０１３年１１月１９日 火曜日 午前１１時５０分