MY Owners Manual

Rear-view camera*
7-68 Starting and driving
7
When you place the select position is the “R”
position with the operation mode in ON, the
view behind the vehicle will automatically
appear on the screen of the Mitsubishi Multi
Communication System (MMCS) or the DIS-
PLAY AUDIO. When you move the selector
lever to any other position, the screen will
return to its original indication.
Reference lines and upper surface of the rear
bumper (A) are displayed on the screen.
 Red line (B) indicates approximately 50
cm behind the rear bumper.
 Two Green lines (C) indicate approxi-
mately 20 cm outside of the vehicle body.
 Short transverse lines (1 to 3) indicate dis-
tance from the rear bumper.
How to use the rear-view cam-
era
CAUTION
 The rear-view camera has a special lens that
can make objects shown on the screen appear
to be closer or further away than they actu-
ally are.
NOTE
 Because the rear-view camera has a special
lens, the lines on the ground between parking
spaces may not look parallel on the screen.
 In the following situations, the screen indica-
tion may be difficult to see. There is no
abnormality.
•Low light (nighttime)
•When the light of the sun or the light from a
vehicle’s headlamps shines directly into the
lens
 If the camera is hot and is then cooled by
rain or a car wash, the lens can mist up. This
phenomenon does not indicate a malfunc-
tion.
 It is not possible to fully see obstacles when
the lens is dirty. If the lens becomes contami-
nated by water droplets, snow, mud, or oil,
wipe off the contamination, taking care not
to scratch the lens.
 Please observe the following cautions. Ignor-
ing them could lead to a camera malfunction.
•Do not subject the camera to physical
shock.
•Do not apply wax to the camera.
•Do not splash the camera with boiling
water.
•Do not disassemble the camera.
Reference lines on the screen
1: Approximately at the rear edge of the
rear bumper
2: Approximately 100 cm
3: Approximately 200 cm
BK0203201EN.book 68 ページ ２０１３年１１月１９日 火曜日 午前１１時５０分