MY Owners Manual

Automatic climate control air conditioner
8-6 For pleasant driving
8
The settings described above are the factory
settings.
The air selection and air conditioning
switches can be customised (function setting
changed), and the automatic switching of out-
side air and the air conditioner according to
operating conditions can be changed as
desired.
For further information, we recommend you
to consult a MITSUBISHI MOTORS Author-
ised Service Point.
Refer to “Customising the air conditioning
switch” on page 8-8.
Refer to “Customising the air selection” on
page 8-7.
The driver’s side and the passenger’s side
temperature can be controlled independently.
At this time, the “DUAL” indicator will be
shown in the display (A).
 Synchronized mode
If the driver’s side temperature control
switch is pressed, the passenger’s side
temperature will also be controlled to the
same setting temperature as the driver’s
side.
 Dual mode
If the passenger’s side temperature con-
trol switch is pressed under synchronized
mode, the system will switch to dual
mode. In dual mode, the driver’s side and
the passenger’s side temperature can be
set separately by using each temperature
control switch.
Press the AUTO switch to return to syn-
chronized mode.
E00703401808
To change the air selection, simply press the
air selection switch.
NOTE
 The temperature value of air conditioner is
switched in conjunction with outside temper-
ature display unit of the multi information
display.
Refer to “Changing the temperature unit” on
page 6-17.
 While the engine coolant temperature is low,
the temperature of the air from the heater
will not change instantly, even if you have
selected warm air with the switch.
To prevent the windscreen and windows
from fogging up, the ventilator mode will be
changed to “ ” and the blower speed will
be reduced while the system is operating in
the AUTO mode.
 When you feel that it is hot or cold to the set-
ting temperature, it is possible to adjust so
that you can feel more comfortable.
For further information, we recommend you
to consult a MITSUBISHI MOTORS
Authorised Service Point.
 When the temperature is set to the highest or
the lowest, the air selection and the air condi-
tioner will be automatically changed as fol-
lows.
Also, if the air selection is operated manually
after an automatic changeover, manual oper-
ation will be selected.
•Quick Heating (When the temperature is set
to the highest setting)
Outside air will be introduced and the air
conditioner will stop.
•Quick Cooling (When the temperature is set
to the lowest setting)
Inside air will be recirculated and the air
conditioner will operate.
 When the air conditioner is set to quick heat-
ing, the engine starts running (except vehi-
cles with electric heater).
 Synchronized mode and dual mode
NOTE
Air selection switch
BK0203201EN.book 6 ページ ２０１３年１１月１９日 火曜日 午前１１時５０分