MY Owners Manual

How to change a tyre
9-18 For emergencies
9
12. Check your tyre inflation pressure at the
next gas station. The correct tyre pres-
sures are shown on the driver’s door label.
See the illustration.
E00803800037
Reverse the removing procedure when stor-
ing the jack, jack bar and wheel nut wrench.
Refer to “Tools and jack” on page 9-6.
E00801300735
Wrap the tip of the jack bar with a cloth,
insert it into the notch provided in the wheel
cover, and pry the cover away from the
wheel. Using the same procedure at the other
wheel cover notches, work the wheel cover
away from the wheel to remove it completely.
1. Make sure the tabs (A) of the back of the
wheel cover are not broken and correctly
fitted on the rings (B). If in doubt, do not
install the wheel cover and consult your
MITSUBISHI MOTORS Authorised Ser-
vice Point.
CAUTION
 After changing the tyre and driving the vehi-
cle about 1000 km, retighten the wheel nuts
to make sure that they have not come loose.
 If the steering wheel vibrates when driving
after changing the tyre, we recommend you
to have the tyres checked for balance.
 Do not mix one type of tyre with another or
use a different size from the one listed. This
would cause early wear and poor handling.
To store the tools and jack
Wheel covers*
To remove
CAUTION
 Removing the cover with your hands may
cause injury to the fingers.
NOTE
 The wheel cover is made of plastic. Pry it
loose carefully.
To in s ta l l
BK0203201EN.book 18 ページ ２０１３年１１月１９日 火曜日 午前１１時５０分