MY Owners Manual

Charging troubleshooting guide
3-16 Charging
3
Normal charging can-
not be started.
There is no electrical power
coming from the outlet.
Confirm that there has not been a power failure. Make sure the breaker is on. If an outlet
with a timer device installed is used, power will only be available at the time set by the
timer.
Confirm if the POWER indicator on the control box is illuminated.
The charge connector is not
connected correctly.
Confirm the charge connector is connected correctly.
The charge connector was
connected and disconnected
repeatedly in a short time.
Disconnect the charge connector, wait for a while, then start charging procedure again
from the beginning.
A charging cable for other
vehicle is used.
Use the EV charging cable only for your vehicle.
A normal charger which does
not correspond to your vehi-
cles is used.
Consult an administrator or a maker of the normal charger that it corresponds to your
vehicle. Also perform normal charging according to the operating procedure indicated
on the body of normal charger.
Reservation of charging timer
is set up by MITSUBISHI
Remote Control. (Vehicle
with MITSUBISHI Remote
Control)
The normal charging can not be started when the charging cable is connected, if the
charging timer is set. Cancel all the charging timer settings, if you want to start the nor-
mal charging immediately.
Symptom Possible cause Possible solution
BK0203201EN.book 16 ページ ２０１３年１１月１９日 火曜日 午前１１時５０分