MY Owners Manual

Security alarm system*
Locking and unlocking 4-27
4
By locking the vehicle using the keyless
entry system or the keyless operation
function, the system preparation mode is
activated.
The buzzer makes an intermittent beeping
sound and the security indicator (D) in the
centre panel flashes for confirmation.
4. After approximately 20 seconds, the
buzzer stops, and when the blinking of the
security indicator starts to slow down, the
system armed mode goes into effect.
The security indicator continues to blink
during the system armed mode.
E00312101416
The vehicle inclination detection function and
the interior intrusion detection function can
be deactivated when parking in automated car
parks or leaving pets in the vehicle or leaving
the vehicle with the windows slightly open.
1. Put the operation mode in OFF.
2. Raise and hold the wiper and washer
switch to the “MIST” position for about 3
seconds. The buzzer will sound once and
the function will be deactivated.
To activate the function again, raise and hold
the wiper and washer switch to the “MIST”
position for about 3 seconds.
The buzzer will sound twice and the function
will be activated.
Tailgate LOCK switch*
NOTE
 The system preparation mode is not activated
when the doors and the tailgate have been
locked using a method other than the keyless
entry system or the keyless operation func-
tion (namely a key, the inside lock knob or
the central door lock switch).
 If the bonnet is open, the security indicator
illuminates, and the system does not enter
the system preparation mode.
When the bonnet is closed, the system enters
the system preparation mode, and after about
20 seconds the system enters the system
armed mode.
NOTE
 The security alarm system can be activated
when people are riding inside the vehicle or
when the windows are open. To prevent acci-
dental activation of the alarm, do not set the
system to the system armed mode while peo-
ple are riding in the vehicle.
 Avoid leaving valuable items inside the vehi-
cle even when the security alarm system has
been set to the “active” mode.
To deactivate the vehicle inclina-
tion detection function and the
interior intrusion detection func-
tion
BK0203201EN.book 27 ページ ２０１３年１１月１９日 火曜日 午前１１時５０分