Owners Manual

Bluetooth® 2.0 interface (if so equipped)
Features and controls 5-57
5
5. The voice guide will say “Confirmation
prompts are <off/on>” and then the sys-
tem will return to the main menu.
N00564601163
It is possible to use a passcode as a security
function by setting a passcode of your choice
for the Bluetooth
®
2.0 interface.
When the security function is turned on, it is
necessary to make a voice input of a 4-digit
passcode in order to use all functions of the
Bluetooth
®
2.0 interface, except for recep-
tion.
Use the following procedure to turn on the
security function by setting a passcode.
1. Press the PICK-UP button.
2. Say “Setup.”
3. Say “Passcode.”
4. The voice guide will say “Passcode is dis-
abled. Would you like to enable it?”
Answer “Yes.”
Answer “No” to cancel the setting of the
passcode and return to the main menu.
5. The voice guide will say “Please say a 4-
digit passcode. Remember this passcode.
It will be required to use this system.”
Say a 4-digit number which you want to
set as a passcode.
6. For confirmation purposes, the voice
guide will say “Passcode <4-digit pass-
code>. Is this correct?” Answer “Yes.”
Answer “No” to return to the passcode
input in Step 5.
7. When the registration of the passcode is
completed, the voice guide will say “Pass-
code is enabled” and the system will
return to the main menu.
If a passcode has been set and the security
function is enabled, the voice guide will say
“Hands-free system is locked. State the pass-
code to continue” when the PICK-UP button
is pressed to enter voice recognition mode.
Say the 4-digit passcode number to enter the
passcode.
If the entered passcode is wrong, the voice
guide will say “<4-digit passcode>, Incorrect
passcode. Please try again.” Enter the correct
passcode.
Use the following procedure to turn off the
security function by disabling the passcode.
1. Press the PICK-UP button.
2. Say “Setup.”
3. Say “Passcode.”
4. The voice guide will say “Passcode is
enabled. Would you like to disable it?”
Answer “Yes.”
Answer “No” to cancel the disabling of
the passcode and return to the main menu.
Security function
Setting the passcode
NOTE
 Passcode will be required to access the sys-
tem after restarting the electric motor unit.
 It is required for a little time after the ready
indicator has turned off that the entered pass-
code is actually recorded in the system. If the
electric motor switch is made to “ACC” or
“ON” or the electric motor is started immedi-
ately after the ready indicator has turned off,
there is a case when the entered passcode is
not recorded in the system. At this time,
please try to enter the passcode again.
Entering the passcode
NOTE
 You can reenter the passcode as many times
as you want.
 If you have forgotten your passcode, say
“Cancel” to quit the voice input mode and
then check with a certified i-MiEV dealer.
Disabling the passcode
NOTE
 System must be unlocked to disable the pass-
code.
BK0220400US.book 57 ページ ２０１４年１１月１８日 火曜日 午前７時２７分