Owners Manual

HomeLink® Wireless Control System (if so equipped)
Features and controls 5-111
5
N00584600029
 Some garage door openers manufactured
after 1995 have “rolling code protection”.
To program a garage door opener
equipped with “rolling code protection”;
you will need to access the garage door
opener motor to press the motor’s “Learn”
or “Smart” buttons. For convenience, use
a ladder and another person to assist you.
 It is recommended that a new battery be
placed in the hand-held transmitter of the
device being programmed to HomeLink
®
for quicker training and accurate trans-
mission of the radio-frequency signal.
N00584700020
To program HomeLink
®
to operate a garage
door, gate, or entry door opener, home or
office lighting, you need to be at the same
location as the device.
1. Press the HomeLink
®
button that you
would like to program. The indicator light
(A) will flash orange slowly.
 During programming, your garage door
or gate may open or close. Make sure that
people and objects are clear of the garage
door or gate that you are programming.
NOTE
 Once HomeLink
®
is programmed, retain the
original transmitter for future programming
procedures (for example, new vehicle pur-
chases). Upon sale of the vehicle, the pro-
grammed HomeLink
®
buttons should be
erased for security purposes. Refer to
“Cleaning the programmed information” on
page 5-114.
 You can program a maximum of 3 devices.
To change or replace any of the 3 devices
after it has been initially programmed, you
must first erase the current settings.
See “Cleaning the programmed information”
on page 5-114 or “Reprogramming a single
HomeLink
®
button” on page 5-115.
WARNING
1-
HomeLink
®
button 1
2-
HomeLink
®
button 2
3-
HomeLink
®
button 3
Before programming Home-
Link
®
Programming a new Home-
Link
®
NOTE
 You do not need to continue holding the
HomeLink
®
button.
 If the indicator light does not flash, refer to
“Cleaning the programmed information” on
page 5-114.
BK0236100US.book 111 ページ ２０１６年２月１日 月曜日 午前１０時１５分